Kenmore 106.53592
The icemaker does not make ice. The wire lever is down. I've removed and reset the icemaker. The freezer is working and water is dispensing at the door. My next step is to check for a frozen/clogged water line to the icemaker. If no this then what's next? Thanks. Answer If the line is clogged unclog it and replace the water valve. If the line isn’t clogged pull the front off the icemaker. Once done you should see test holes marked with letters. Make a jumper wire using a short piece of insulated wire skinned on both ends. Then place one end in the hole marked H and the other in the hole marked T. Once done the icemaker should cycle and run water. If it cycles but doesn’t run water replace the water valve. Click picture to order. If it doesn’t cycle replace the motor/modular. Click picture to order. If it cycles and runs water but will not cycle again replace the whole icemaker. Click picture to order. For more on this use this page Whirlpool icemaker repair Thank you, Shawn/administrator |